Custom Gang Sheet - Upload a Pre-Made 22"w X 12"h Sheet

Ranging from 2ft to 20ft, these gang sheets accommodate orders of all sizes. For beginners or those without design software, Our Bult in Designer is the perfect solution. With a user-friendly interface and an array of customization tools, building a gang sheet has never been easier. Simply upload HIGH RESOLUTION, print-ready artwork, adjust sizes, and easily duplicate images. The builder ensures optimal layout and provides seamless checkout, making it easy to create and order your DTF gang sheets. Embrace creativity and revamp your printing process with our DTF Gang Sheet Builder.

Pressing Instructions
To ensure your DTF transfer looks professionally pressed every time, follow these four simple steps.

1. Position Your Design

Position your transfer in the desired location and make sure you are not pressing over large wrinkles. Heat-resistant tape is recommended when pressing on hats or when using a household iron to prevent the transfer from moving. You'll learn when it's needed with experience

2. Press

Press the transfer at 310°F / 155°C with medium to high pressure for 10 seconds. It is always recommended to test one piece first. Use a Silicone Upper Platen Cover & Garment Protector to protect your garment from touching the iron directly. You cannot damage the transfer by pressing with more heat, pressure, or time, however, it could scorch the garment.  

If your settings are scorching the garment, the first step would be to reduce pressure. If that doesn’t work, retain the reduced pressure and reduce the heat by 10-15°F.  With a little practice, you’ll find the right settings for each garment and material.

3. Peel Hot After a Few Seconds

With Our DTF Transfers, you can peel hot or cool. Wait a few seconds (or more) and peel! If parts of the design are not sticking, lay it back down and press again with added pressure and heat (+15°F).  If unsuccessful, increase heat by 15°F increments until it works. 

4. Final Press & Wash Instructions

Important: While the majority of other DTF companies advise you to press it just once, this is IMPROPER. After hundreds of wash tests, we have found that a final press is imperative to create a superior product.

After the design is transferred onto the garment, with the film peeled off, cover the design with provided parchment paper or a single layer of t-shirt material and press for ~15 seconds. By doing so, it enhances the value of your product by greatly improving the durability and softness as well as reducing the shine. For a glossy look, use a guard sheet for the second and final press instead. For best results and longevity, wash the garment inside out in cold water and dry on low heat or hang to dry. Washing it with standard settings is fine, but it lasts longer with more delicate settings.